Surpass Hobby ROCKET PLUS LED Program Card for 80A ESC Speed Controller RC Car Vehicles Model Parts
Instructions
1. Connect BEC wires with the receiver
2. Connect motor wires with ESC
3. Turn on the transmitter
4. Connect battery pack with ESC then switch on the ESC
5. When the connection of motor and battery is finished the motor emits 'Beep' tone
6. When the throttle stick is in the neutral position the motor re-emits 'Beep' tone
7. The ESC is workable
Troubleshooting
1. If after power on motor can't work no sound is emitted please check the connections between battery pack and motor.
2. If the motor emits a 'Beep' tone Only please check all the connections: BEC wires transmitter and receiver throttle signal wires etc. please check the transmitter TH.TRIM and adjust it to the motor re-emits 'Beep' tone.
3. If the car can't be speed up please check either voltage of the battery pack is too low or the temperature of ESC is too high. If the voltage of the battery pack is too low please replace the battery pack. If the temperature of ESC is too high please check all connections. If not please push the button EPA on your remote control.
4. If the car stops suddenly while in working state please check the motor's connections and the roadblock.
5. If the car runs in the opposite direction which the transmitter is available please swap two wire connections between the ESC and the motor.
Package Included:
1x Rocket LED Program Card